Yokogawa ADM11 S3 Module

Yokogawa ADM11 S3 100% New Module

Overview

The CS3000 software requires Microsoft Windows 3.1 or later versions (including Windows 98 or Windows NT). Make sure Windows is installed and configured on your personal computer before attempting to install the CS3000 software

Before installing and using the CS3000 software make sure you have the following hardware: 

• An IBM or IBM-compatible 486 or Pentium personal computer running Windows 3.1, Windows 98, or Windows NT. 

• 16 Mbytes of RAM (minimum) 

• A hard drive with at least 1 Mbytes free space available for the CS3000 software 

• A 3.5" floppy drive 

• A Monochrome or color monitor: VGA or better 

• An RS-232 serial COM port for communicating with the drive 

• An RS-232 serial cable with: 

  • A 25-pin or 9-pin D-shell connector for your personal computer 

  • A 9-pin or 25-pin male D-shell connector for the drive.

The GV3000 drive is equipped with a terminal strip as well as a 9-pin D-shell connector. Either one can be used to connect to the personal computer. Refer to section 2.3.1 for additional information.

More Products

You May Need

Popular Searches

1.Allen-Bradley 1756/1769/1771/1785 Series

2.ABB 800xA/Bailey INFI90/DSQC Series

3.Bently Nevada 3500/3300 Monitoring System

4.Schneider Series Quantum 140 series

5.General Electric IC693/IC697/IC698/IS200/DS200 Series

6.SIEMENS MOORE/S5 Series

7.Westinghouse: OVATION/WDPF/MAX1000 system spare parts

8.Invensys Triconex: Redundant fault-tolerant control system, Most modern fault-tolerant controller based on Triple Modular Redundancy (TMR) architecture

9.Honeywell TDC2000/TDC3000/Experion HS Series

10.YOKOGAWA CS3000 System